feed undersize and crusher capacity

Effect of Feed Rock Size Distribution on Crusher Performance

2015-10-22  The effect of the undersize in the feed upon the capacity of the crusher depends upon several factors. If the crusher is a primary breaker, and the discharge opening is large, undersize

More

Jaw Crusher - ScienceDirect

2016-1-1  Taggart expressed the relationship between crusher capacity and reduction ratio in terms of a reduction ton or tonne, Q R defined as (4.22) Q R = Q T ⋅ R 80 where Q T is the capacity in terms of actual tonnage crushed per hour. The quantity of feed actually crushed is determined by subtracting the feed undersize from the total quantity of feed.

More

Jaw Crusher - an overview ScienceDirect Topics

The quantity of feed actually crushed is determined by subtracting the feed undersize from the total quantity of feed. The reduction tonnage term is dependent on the properties of the material crushed so that for a given reduction ratio, the crusher capacity will vary for different materials.

More

Crushing Products Size and Shape -What to Expect

2016-2-26  Primary Crusher Product. It was formerly the custom to consider one set of product gradation, or screen analysis, curves as being suitable to represent the products of both primary (unscreened) and secondary feeds, making no allowance for the undersize

More

Capacities and performance characteristics of jaw crushers

2016-2-26  The size characteristics of the feed are important consid- erations. The coarser the feed, the larger the number of crushing stages and degree of compaction the feed has to undergo before it is discharged. It is commonly observed that the degree of compaction of the product decreases with increasing coarseness of the feed. The dependence of the degree of compaction on the relative size of the feed may be studied as a function of the average feed size

More

Crusher - an overview ScienceDirect Topics

The roll crusher consists of a pair of horizontal cylindrical manganese steel spring rolls (Fig. 13.14), which rotate in opposite directions. The falling feed material is squeezed and crushed between the rollers. The final product passes through the discharge point. This type of crusher is used in secondary or tertiary crushing applications.

More

Secondary Crushing Simulation

2017-6-1  Effect of Secondary Crusher Feed Rate. The influence of secondary crusher feed rate (i.e., feed to plant) on responses is shown in Figure 3-A. Standard settings were employed. The reduction ratio, the screen efficiency , and the % -½ inch material in screen undersize are virtually independent of feed rate over the range investigated.

More

Crushing Equipment Selection - Mineral Processing

2016-2-28  If there are only occasional pieces in the feed that exceed about one- half the smallest dimension of the crusher receiving opening, these car sizes may be increased as much as 25 percent. They may of course be exceeded considerably in mining operations where there is a high percentage of undersize which is grizzlied out ahead of the crusher.

More

Principles of Screening and Sizing

2016-1-12  Each opening has a volumetric throughput capacity: • Basic capacity figure is expressed as . tph per sq.ft. • Figure is multiplied by the sq. footage of the screen deck. • Calculation gives the basic capacity of each deck and the total capacity of the vibrating screen. • The vibrating screen capacity

More

Open or Closed Circuit Crushing

2016-2-29  The factors governing the determination of capacity for any open circuit crushing stage are much the same as those we outlined in connection with the

More